kingyoPiyo/Pico-10BASE-T
kingyoPiyo/Pico-10BASE-T has 612 GitHub stars and 19 forks. GitHot measured 0 stars in 24 hours. Last checked 2026-11-15 16:28 UTC. Last push 2024-08-16.
Measured star growth
- in 24h
- 0
- in 7 days
- Update delayed
- in 15 days
- Update delayed
- in 1 month
- Update delayed
Net star changes over overlapping periods, not daily totals. Missing measurements are left blank. Stars measure attention, not software quality.
About
10BASE-T from Raspberry Pi Pico
Developer ToolsREADME.md
OriginalPico-10BASE-T
10BASE-T from Raspberry Pi Pico
Note:
- DO NOT CONNECT to PoE equipment!!
- Currently transmission only (UDP is available)
- Receiving process will be implemented in the future...
- It is advisable to insert a pulse transformer for safety.
See also :
https://github.com/kingyoPiyo/Pico-RJ45-Sock
Setup
- Raspberry Pi Pico
- 2 x 47 ohm resistor
- 1 x 470 ohm resistor
- RJ45 connector(GP16 = TX-, GP17 = TX+)
Have fun!
Ethernet Packet Example
Ethernet Physical layer waveform
Measured with 100Ω termination.
NLP(Normal Link Pulse)
Ethernet Packet overview
Preamble
TP_IDL
How to make a pulse transformer
A simple pulse transformer can be built using ferrite cores that have fallen around!
Adding a transformer ensures insulation and safe experimentation.
Pass it through the core about three times.
Just connect it into the RasPico and you're done!
The waveform after passing through the transformer.
Waveforms of commercial network devices
Physical layer signal waveforms of commercial network equipment operating at 10BASE-T.
Measured with 100Ω termination.