Skip to content
Projects

S-March/dEEbugger_Public

View on GitHub

S-March/dEEbugger_Public has 201 GitHub stars and 18 forks. GitHot measured 0 stars in 24 hours. Last checked 2026-11-18 09:29 UTC. Last push 2017-08-17.

How these counts are measured

Measured star growth

in 24h
0
in 7 days
Collecting history
in 15 days
Collecting history
in 1 month
Collecting history

Net star changes over overlapping periods, not daily totals. Missing measurements are left blank. Stars measure attention, not software quality.

About

The dEEbugger is an ESP8266 based keychain swiss army knife for electronics

Developer Tools

README.md

Original

dEEbugger

The dEEbugger is an ESP8266 based keychain swiss army knife for electronics

Alt text

The device was designed with breakouts for the two ADC channels, UART and I2C. It can run off of 5V or 3.3V or USB power. If USB is being used, the 5V and 3.3V pins can be used as outputs.

Alt text

Oscilloscope

To use the dEEbugger, plug in power and navigate to dEEbugger.local in you browser. If your devices does not support mDNS, you can just navigate to the dEEbugger IP address instead.

Alt text

Two Channels (ADC and UART Stream)

Chose between multiple inputs for the channels. In the below picture the red is an ADC channel and the blue is a UART stream of numbers.

Alt text

Peak Detection

The dEEbugger supports real time peak detection as well.

Alt text

Serial Terminal

Local Echo

In additin to acting as an oscilloscope, the dEEbugger can act as a "wireless" serial terminal allowing you to send and receive data over the UART pins through the web application

Alt text

Terminal Options

Terminal settings: connect/disconnect button, baud rate selection, terminal clear button and enable/disable a local echo.

Alt text

I2C Controller

Find Devices

When "Find Devices" button is pressed, a list of all I2C devices on the bus will be returned.

Alt text

Read Device

When a device is selected, all readable registers will be returned with their current values.

Alt text